Ti200, Ti300, Ti400 Users
Change #1
On page 33, following Torch, add:
CNX™ Wireless System
The Imager supports the Fluke CNX™ Wireless System (may not be available
in all regions). It can discover up to nine CNX 3000 Series wireless tools up to
20 meters away. From those nine, you can select five tools to view their live
measurements on the Imager display.
To discover a supported tool:
1. If not already on, turn on each wireless tool and make sure the wireless
feature is enabled. See the documentation of each tool for more information
about how to use.
2. Turn on the Imager.
3. Go to Camera > CNX.
4. Push / to highlight ON.
The Imager starts the discovery process.
When done, the Imager presents a list with the ID and name of available
tools found within the 20 m distance.
5. Push / to highlight a tool name.
6. Push to select the tool.
7. Repeat steps 5 and 6 for each tool to show on the display.
8. Push when done.
The labels change to include an Edit function. By default, the Imager shows
and saves the data for the selected tools. If these settings are acceptable,
push to exit the CNX setup menu.
To edit the selection:
9. Push / to highlight the tool name.
Push to view the Edit menu. The Edit menu gives you a choice to
10.
display the measurement data and/or save it to the memory card
3/14
1
Manual Supplement
.