Before Start Operation - Condtrol Smart 2D Plus Bedienungsanleitung

EN
LASER LEVEL
Control panel
2
1. Switch on/off the laser emitter / adjust laser line brightness /
switch on/off the pulse mode
2. Power indicator

BEFORE START OPERATION

Install/change alkaline battery
If the power indicators do not light green, replace the batteries.
Remove the battery cover and install the batteries observing
polarity. Close the battery cover until it clicks. Alkaline batteries must
be made by the same brand and have the same charge level.
Laser line brightness adjustment
When the device is switched on, medium brightness of the laser line
is set by default.
Press to adjust required brightness of laser lines: medium
brightness (by default) → maximum brightness → low brightness.
8 8
CONDTROL SMART 2D Plus
user manual
1