Operation Modes - CONDTROL Super RotoLaser Bedienungsanleitung

CONDTROL Super RotoLaser
EN
ROTARY LASER
even if main battery unit is discharged/being charged.
For charging use battery charger included in the set.
Full charging takes approximately 5 hours. While charging red light
indicator on battery charger will be on. As soon as indicator becomes
green, batteries are fully charged, battery charger can be unplugged.
Take batteries out of the product if it is not used for a long time. All
batteries should be of the same type and brand with the same charge
level. Do not leave discharged batteries in the product.
Replace batteries in laser receiver
Battery compartment is located on the back side of laser receiver.
Remove battery cover, take out discharged batteries and install new
ones, observing correct polarity. Put battery cover back.
Use alkaline 9 V 6LR61/6F22 batteries only. Remove the batteries
from laser receiver if it is not used for a long period of time to avoid
corrosion and battery discharging. All batteries should be replaced
simultaneously. All batteries should be of the same type and brand
with the same charge level.
Replace batteries in remote control
Battery compartment is located on the back side of remote control.
Remove the battery cover: slide out the battery cover and remove it.
Insert the batteries, observing correct polarity. Slide the cover back
until a click is heard.
Use alkaline AA batteries only. Remove the batteries from remote
control if it is not used for a long period of time to avoid corrosion and
battery discharging. All batteries should be replaced simultaneously.
All batteries should be of the same type and brand with the same
charge level.
12
EN
ROTARY LASER
user manual
Turn on/off the product
Press button

OPERATION MODES

Automatic mode (build horizontal/vertical plane)
Place the product on a flat surface or tripod 5/8" in horizontal or
vertical position.
Turn on the product. Symbol
beam flash while self-levelling. As soon as self-levelling is finished
symbol
600 rpm.
If the product is out of self-levelling range(5°), the product will emit
sound signal. Laser beam will flash as well, rotary head will not rotate.
Turn off the product and turn it on again.
Press button
the display. If the product is unbalanced by some external influence,
it will not perform self-levelling again. You will hear sound signal,
symbol
turn it on and repeat operation.
Build inclined planes
This mode allows building inclined planes tilted up to ±10% for the
axes X and Y.
Press button
appear on the display. Value of tilt angle for axis X is flashing in the
CONDTROL Super RotoLaser
, to turn on/off the product.
on the display as well as laser
turns off, rotary head starts rotating clockwise at
to switch to tilt mode. Symbol
will appear on the display. Turn off the product, then
to enter inclined planes mode. Symbol
user manual
appears on
will
13