CONDTROL XLINER 360 G Bedienungsanleitung Seite 9

EN
LASER LEVEL
OPERATION
Before start operation remove the battery cover, insert the batteries,
observing correct polarity. Put battery cover back.
Use AA alkaline batteries only, all batteries should be of the same type
and brand with the same charge level. Replace batteries if battery
charge level indicator starts flashing red while operation.
Place the laser level on a firm and stable surface or a tripod.
Move compensator lock to choose necessary operating mode:
1) Automatic levelling:
Move lever lock to ON position
Compensator is unlocked. Power indicator becomes red. If the laser
level is out of the range of automatic compensation laser lines flash.
Short press button
Short press button
working with laser receiver. In this mode pulse mode indicator will
turn red. To switch the laser level off move compensator lock to locked
position .
2) Locked compensator, to build inclined planes and lines:
Move compensator lock to OFF position
Power indicator becomes red. Press and hold button
during 3 seconds to switch the laser level on.
Short press button
Activated laser lines flash every 5 seconds in this mode.
XLiner 360 G / COMBO 360 G
.
to switch on necessary laser planes.
to switch on/off pulse mode that allows
to switch on necessary laser planes.
user manual
. Compensator is locked.
9 9