Operation - CONDTROL smart 25 Bedienungsanleitung

LASER DISTANCE
Smart 25 CONDTROL
EN
METER
Display
1 2
6
1. Laser indicator
2. Reference point
3. Continuous measurement (tracking)
4. Battery charge level
5. Measuring unit
6. Display line

OPERATION

Insert/replace batteries
Remove the battery cover. Insert the batteries, observing
correct polarity. Put the battery cover back. Remove the
batteries when the
product is not used for
a long time to avoid
corrosion and battery
depletion. Both batteries
should be replaced at the
same time. Both batteries
must be of the same
brand with the same
charge level. Replace
batteries when symbol
is constantly
flashing on the display.
6
User manual
3 4
5
LASER DISTANCE
Smart 25 CONDTROL
EN
METER
Prepare replaceable batteries when symbol
illuminated on the display. You can produce around 100
measurements after this symbol appeared.
Turn on/off
Turn on: press button
The product will turn on and enter single distance measuring
mode. Laser beam will turn on simultaneously. Laser beam
automatically turns off in 30 seconds after the last operation.
Turn off: the product will turn off automatically in 60 seconds
after last operation.
Display backlight
When the product is on, backlight turns on automatically
when you press button
automatically in 15 seconds after last operation.
Reference point
Reference point is the bottom end of the product.
Measurements
1) Single distance measurement
Press button to turn on the product. Laser beam will
be on. Point the laser beam at the target and press button
for single distance measurement. The result of
measurement will appear on the display. Laser beam remains
on. To perform next single distance measurement press
button .
User manual
is
. The backlight will turn off
7