Adjusting Weeder For User - Stihl Rga 140 Gebrauchsanleitung

9 Adjusting Weeder for User

1
2
3
4
5
► Remove the wing screw (1).
► Remove the clamp moldings (2 and 4).
► Place the handlebar (3) in the lower clamp
molding (4).
► Fit the upper clamp molding (2).
► Insert the spring (5) from below into the lower
clamp molding (4).
► Place the clamp moldings (2 and 4) on the
shaft and insert the wing screw (1).
► Swing the handlebar (3) up.
► Tighten the wing screw (1).
► Remove the screw (6).
► Position the control handle (7) on the handle‐
bar (3), trigger facing the gear housing, and
line up the hole in the control handle with the
hole in the handlebar.
► Fit the nut (7).
► Screw in and securely tighten the screw (6).
It is not necessary to remove the bike handle
again.
8.2 Mounting the gear housing
1
2
► Loosen the screw (4).
► Push the shaft (1) into the gear housing (3)
and turn it until the gear shaft (2) engages.
► Tighten the screw (4) slightly.
► Position the gear housing (3) so that it faces
upward.
► Tighten the screw (4) securely.
The gear housing does not need to be removed
again.
0458-845-9802-A
7
6
3
3
4
9 Adjusting Weeder for User
9.1 Fitting and Adjusting the Full
8
Harness
► Putting on the Full harness (1).
► Adjust the full harness (1) so that the carabi‐
ner (2) is about a hand's width below your
right hip.
9.2 Adjusting the Bike Handle
The bike handle can be set to different positions
to suit the height and reach of the user.
► Switch off the weeder and remove the battery.
► Use the perforated strip to hook the weeder
into the carabiner of the carrying system.
► Loosen the wing screw (1).
► Swing the bike handle (2) to the required posi‐
tion.
► Tighten the wing screw (1) securely.
9.3 Balancing the weeder
The battery affects the balance of the weeder.
The weeder must be balanced with the battery
used.
► Switch off the weeder.
1
2
2
1
1
2
English
35