SRAM T3 Montageanleitung Seite 12

Assembly / Cable Change
Caution:
The SRAM T3 hubs are not
suitable for tandems, trademen's
delivery bicycles and similar.
A S S E M B L Y S H I F T E R
• Slide shifter (1, Fig 4) onto
handlebar.
• Mount fixed grip (2) onto end
of handlebar.
• Slide shifter against fixed grip,
adjust shifter on handlebar and
tighten with bolt (3) with a
torque of 1.7 Nm (15 in. lbs.).
• Not recommended for use on
thin walled aluminum handle-
bars such as Hyperlite ®
handlebars.
Caution:
• Check that the shifter and
brake lever function properly
and are unobstructed (realign
if necessary).
4
1
3
5
type
• Fixed grips provide an axial
safety function. For this reason,
they should be mounted in such
a way as to make sure they do
not slip off handlebar.
• Never use lubricants or solvents
to install fixed grips.
A S S E M B L Y L O C A T I N G
S L E E V E
• Set shifter in gear position „3".
• Feed the control cable (5, Fig. 6)
into the locating sleeve, fix at the
appropriate length using the
2
clampingbolt (1). Allan key
2.5 mm, tightening torque 1.5 Nm
(7 – 8.8 in.lbs).
C A B L E C H A N G E
(see Fig. 5)
• Set shifter in gear position „3".
• Leave the shifter on the handlebar.
• No need to move other compo-
nents.
• Use only new cable and
compressionless cable housing.
• Detach the cable from the
locating sleeve.
• Remove the cable housing. Cut
the cable off 15 cm (6") from the
shifter. Discard the old cable and
cable housing.