Spare Parts For Rv 2 Pre-Installation Kit; Storage, Environmental Influences; Environmentally Responsible Disposal; Company Information - Maico Rv 2 Vh Montageanleitung

15 Spare parts for RV 2 pre-installation kit

3. Ensure that the plaster frames are correctly
positioned, aligned and sealed with the plaster
protection on the inside and outside. The
frames must not protrude from the finished
plaster (max. flush, rather protruding inwards).
Ensure that the plaster protection is firmly fit-
ted.
4. Plaster the soffit.
Leave the plaster protection in the mount-
ing sleeve until final installation.
15 Spare parts for RV 2 pre-in-
stallation kit
For inquiries, contact
Maico Elektroapparate-Fabrik GmbH
Steinbeisstraße 20
78056 Villingen-Schwenningen,
Deutschland
Tel. +49 7720 694 445
Fax +49 7720 694 175
E-mail: ersatzteilservice@maico.de
Item Designation
1 RV 2 ARI internal
plaster frame, white
plastic, 4 screws
2 RV 2 PDS plaster pro-
tective cover set: Inner
cover and outer cover +
EPS strips for 90° soffit
16 Storage, environmental influ-
ences
• RV 2 mounting sleeves should only be stored
horizontally and in a dry place. Storage temper-
ature -25°C to +60 °C.
• Avoid high humidity, formation of condensation
and excessively long storage times.
• Protect the mounting sleeve from damage
(knocks, impacts, etc.).
• Do not store the mounting sleeve in an environ-
ment with corrosive substances. Protect the
mounting sleeve from dust, moisture and sun-
light.
36
17 Environmentally responsible
disposal
When demolishing buildings or parts of build-
ings, separate the polystyrene rigid foam com-
ponents from other materials. Dispose of poly-
styrene in compliance with the regulations valid in
the country where you are.
Article no.

Company information

E059.1269.0000
© Maico Elektroapparate-Fabrik GmbH. Trans-
lation of the original operating instructions. Mis-
prints, errors and technical changes are reserved.
E059.1274.0000
The brands, brand names and protected trade
marks that are referred to in this document refer
to their owners or their products.
Packaging and waste equipment contain
valuable, recyclable materials. According
to the Electrical and Electronic Equip-
ment Act and the WEEE Directive, these
must not be disposed of in the domestic
waste. Dispose of them in an environment-
ally friendly manner, in compliance with
the regulations valid in the country where
you are.
For more information → https://
www.maico-ventilatoren.com/ser-
vice/entsorgung.