Applying Façade/Plaster; Mounting Stainless Steel External Cover (Final Installation); Spare Parts For Rv 2 Vs And; Rv 2 Vs 90E - Maico Rv 2 Vs Montageanleitung

15 Mounting stainless steel external cover (final installation)

14.7 Applying façade/plaster
ATTENTION: During the shell construction
phase, protect the installation unit from con-
tamination.
1. Mask the opening of the 90° deflection unit
for renovation work on the outside wall with
suitable adhesive tape.
2. On the inside of the wall, protect the mounting
sleeve of the pre-installation kit for renova-
tion work with the enclosed plaster protective
cover.
3. Professionally install façade insulation on the
exterior wall and plaster the façade. Comply
with valid building regulations.
15 Mounting stainless steel ex-
ternal cover (final installation)
The condensate drainage channel inside the
mounting sleeve has a slope to the exterior
wall. The drainage channel must not be dirty
or damaged, otherwise the condensate cannot
drain properly.
The stainless steel external cover is installed as
follows once the plastering and painting work has
been completed.
1. Remove the plaster protective cover of the in-
ternal cover and the adhesive tape on the ex-
terior wall.
2. Clean the 90° deflection unit for renovation
work and the channel.
24
1 90° deflection unit for renovation work
2 Stainless steel holder with drip edge
3 Fixing screws, 4 pcs.
4 Stainless steel external grille
5 Fixing screws, 2 pcs.
3. Seal the stainless steel holder with silicone
and press onto the 90° deflection unit for
renovation work, align and fasten with the 4
screws provided.
4. Fasten the stainless steel external grille with
the two enclosed screws.
WARNING Danger to health from mould
formation due to building and moisture dam-
age caused by incorrect installation or non-
compliance with building regulations.
Ensure that the condensation drip edge of the ex-
ternal grille protrudes 20 to 25 mm beyond the
external plaster/façade.
16 Spare parts for RV 2 VS and
RV 2 VS 90E
For inquiries, contact
Maico Elektroapparate-Fabrik GmbH
Steinbeisstraße 20
78056 Villingen-Schwenningen,
Deutschland
Tel. +49 7720 694 445
Fax +49 7720 694 175
E-mail: ersatzteilservice@maico.de