Adjusting The Auxiliary Handle - Vevor R7311 Originalanleitung

WARNING: Always ensure that the tool is switched off and the plug is
removed from the power supply, before fitting or removing sanding discs.
Note: DO NOT continue to use worn,torn or heavily clogged sanding discs.
Ensure foreign objects, such as nails and screws,are removed from the
work-piece before starting to sand.
WARNING: DO NOT use a sanding disc on wood that has previously been
used on metal.This may cause scouring on the wooden surface.
· In order for the dust extraction system to function,this sander must only
be used with punched sanding discs with holes that match the holes in the
Hook and loop backing pad(I):
1. Remove the old sanding disc (K)(if fitted),by peeling it away from the
Hook and loop backing pad(I).
2. Remove any dust or debris from the Hook and loop backing pad(I).
3. Match the holes in a suitable disc with the holes in hook and loop
backing pad (I).
4. Simply press the disc on to the pad to attach it.
Note: To maximize the life of the hook and loop base, peel the sanding disc
off slowly rather than rapidly removing it to avoid damage to the hook and
loop system.
WARNING: Take care to regularly clean out the build-up of dust on the
base underneath the sanding disc and not to let the disc wear completely
down before replacing it. Failure to observe these two precautionary
measures can lead to damage to the hooks and loops on the base, and the
sanding disc will not attach properly.

4. Adjusting the auxiliary handle

● Screw auxiliary handle (B) on the right or the left of the tool (depending
on the work to be carried out).
5. Mounting of accessories
· The holes of the sanding disc are lined up with the holes of the backing
pad.
● Before using the tool
● Ensure that accessory is correctly mounted
● Check if accessory runs freely by turning it by hand
● Test-run tool for at least 30 seconds at highest no-load speed in a safe
- 13 -