Switching On And Off - Vevor R7311 Originalanleitung

Note: To determine the sanding mode the sander is currently set to,
disconnect the tool from the power supply, and attempt to turn the Hook
and loop backing pad (I) by hand. If the pad is hard to turn and moves on
an eccentric orbit, Forced rotation mode is selected. If the base turns easily
around its axis, the sander is set to Free run mode.

8. Switching on and off

WARNING: DO NOT switch the tool on or off whilst under load, as this will
greatly decrease the service life of the On/off switch (F).
1. Connect the plug to the power supply
2. Hold the tool securely with both hands, one on the main handle, the
other on the Front grip (G) or Auxiliary handle (B), and make sure that you
have full control at all times.
3. Ensure the tool is not in contact with the work-piece before commencing
with switching on.
4. Push the On/off switch (F) forward until it engages, to start the machine.
5. Push down on to the bottom of the On/off switch (F), to disengage the
switch and stop the machine.
WARNING: Lift the machine off the work-piece before switching off.
WARNING: Always wait until the machine has stopped vibrating
completely before putting it down. Always disconnect from the power
supply after use.
- 15 -