VEVOR R7311 Originalanleitung Seite 9

direction of the wheel's movement at the point of pinching. Abrasive wheels
may also break under these conditions. Kickback is the result of power tool
misuse and/or incorrect operating procedures or conditions and can be
avoided by taking proper precautions as given below.
a) Maintain a firm grip on the power tool and position your body and arm to
allow you to resist kickback forces. Always use auxiliary handle, if provided,
for maximum control over kickback or torque reaction during start-up. The
operator can control torque reactions or kickback forces, if proper
precautions are taken.
b) Never place your hand near the rotating accessory. The accessory may
kickback over your hand.
c) Do not position your body in the area where power tool will move if
kickback occurs. Kickback will propel the tool in the direction opposite to
the wheel's movement at the point of snagging.
d) Use special care when working corners, sharp edges etc. Avoid
bouncing and snagging the accessory. Corners, sharp edges or bouncing
have a tendency to snag the rotating accessory and cause loss of control
or kickback.
e) Do not attach a saw chain woodcarving blade or toothed saw blade.
Such blades create frequent kickback and loss of control.
● Use this tool for sanding wood、paint removal、polishing.
● Use the sanding paper and sponge pad which are supplied with this tool
● Only use this tool for dry sanding.
● This tool should not be used by people under the age of 16 years
● Always disconnect plug from power source before making any
adjustment or changing any accessory.
● Do not work materials containing asbestos (asbestos is considered
carcinogenic).
GENERAL
- 8 -