Dust Extraction - Vevor R7311 Originalanleitung

position
● Stop immediately in case of considerable vibration or other defects and
check tool to determine the cause.

6. Dust extraction

Note: This sander is designed to be connected to a household vacuum
cleaner hose or workshop dust extraction system. This is the preferred and
most effective method of dust extraction.
WARNING: Always ensure that the tool is switched off and disconnected
from the power supply before attaching or removing any accessories.
WARNING: Always connect the sander to a suitable vacuum cleaner or
workshop dust extraction system if the sanding dust contains harmful
substances, such as particles from old paint, varnish, surface coating etc.
ALWAYS dispose of harmful dust according to laws and regulations.
WARNING: Take special care to guard against harmful and toxic dusts
when sanding lead-based painted surfaces, woods and metals, particularly
if you are unsure about the exact substances involved. All persons entering
the work area must wear a mask specially designed for protection against
the toxic dust and fumes involved. Children and pregnant women MUST
NOT enter the work area. DO NOT eat, drink or smoke in the work area.
● Push a suitable vacuum hose on to the Dust extraction port (C). The Dust
extraction port (C) is designed to fit a 28mm diameter hose.
7. Selecting sanding mode
WARNING: NEVER attempt to operate the Mode selector switch (A) whilst
the tool is running. This will cause tool damage.
Note: when changing from non-geared to geared mode, the base must be
rotated 360° to reset the gear mechanism.
● This sander features two sanding modes, which can be selected over the
Mode selector switch (A) (see below picture):
● Turn the Mode selector switch (A) to the left side, choose coarse
sanding.
● Turn the Mode selector switch (A) to the right side, choose fine sanding.
WARNING: DO NOT switch on the tool when the Mode selector switch (A)
is in between settings, This will cause damage to the gears.
- 14 -