B) Display Of The Measuring Data At More Than 2 Outdoor Sensors; C) Switching Between °C/°F Temperature Units (Basis Station) - Renkforce 1380335 Bedienungsanleitung

b) Display of the Measuring Data at more than 2 Outdoor Sensors

If you have registered more than 3 outdoor sensors to the basis station, you can either
display the measured data manually or activate an automatic display.
Have Measuring Data Displayed Manually
• Push the button "CHANNEL/+" (16) briefly repeatedly until the arrow symbol (8) is to
the left of the indoor temperature.
• If you push the "CHANNEL/+" button (16) again briefly (several times if necessary), the
display "IN" will disappear and the channel number (3....8) and the associated measured
data will appear below, depending on how many outdoor sensors are registered.
This is, of course, only possible if further outdoor sensors are actually registered with
the transmission channels 3 - 8. Otherwise, the display "IN" remains.
Changing the Measuring Data Automatically
This is only possible if outdoor sensors with the transmission channels 3 - 8 are
registered.
• Push the button "CHANNEL/+" (16) briefly repeatedly until the arrow symbol (8) is to
the left of the indoor temperature.
• If you push the "CHANNEL/+" button (16) again now (several times if necessary), the
symbol " " (2) will be shown in the lower left of the display at some point.
When the icon "
between the indoor temperature ("IN") and the measured values of the outdoor sensors
3 - 8 (if logged on). The corresponding channel number (3) is displayed.
c) Switching between °C/°F Temperature Units (Basis Station)
• Push the button "CHANNEL/+" (16) briefly repeatedly until the arrow symbol (8) is to
the left of the indoor temperature.
• Push the button "ALARM/ADJUST" (15) for about 3 seconds to switch between the
temperature unit °C (degrees Celsius) and °F (degrees Fahrenheit).
38
" (2) is displayed, the basis station in the lower display line switches