Further Setting Options Of The App; Specifying Values For Measurements - Renkforce A610 Bedienungsanleitung

All manuals and user guides at all-guides.com

11. Further Setting Options of the App

a) Specifying Values for Measurements
Once you select the newly coupled device on the display of the
mobile end device, the app switches to new screen content. You
will be informed by display that you need to specify parameters.
When you select "Setting", the app will switch to the setting screen
(figure 5).
In this display, you can see the name of the device at the upper left
(e.g. Logger 1). In the upper right, there is the button "Done", which
can be used to confirm the settings and complete them.
The button "Start" is in the lower right. Tapping this symbol will start
measurement with recording. The parameters for this are specified
first as described in the following chapters. Some alarm messages
are output as well. Warning signals will sound during this at the
thermo logger as well as the mobile end device. The mobile end
device will also display a warning message that indicates the re-
sult. If you tap "OK" in this display, the alarm will be interrupted.
Alternatively, you can stop the alarm by keeping the Bluetooth
button pushed for a few seconds.
42
When first setting up measuring parameters, you will be
sent directly to the setup page. If any settings have been
made there already, you can choose between "Back" or
settings as shown in the third figure. If you have already
entered anything, "Back" will be displayed as well. If
you select "Back", you will be right in the display menu,
where you can start a measurement.
®