Inserting Batteries In The Outdoor Sensors; C) Inserting Batteries Into The Basis Station - Renkforce 1380335 Bedienungsanleitung

b) Inserting Batteries in the Outdoor Sensors
First open the battery compartment and set the transmission channel and
temperature unit for the display shown via the DIP switches; see chapter 8. a).
• Insert 2 type AAA/Micro batteries into each outdoor sensor in the correct polarity
(observe plus/+ and minus/-).
• Right after inserting the batteries, the outdoor sensor will briefly display all display
segments. If only chaotic characters appear in the display, take out the batteries for
a few seconds and insert them again.
• Close the battery compartment again. For this, put on the battery compartment lid
properly and screw it on.
• The display shows the channel number (21). It will later be used to assign the indication
in the display of the basis station.
At each transmission process of the outdoor sensor (the measuring data are
transmitter in this), the red LED (22) at the front of the outdoor sensor will flash
briefly.

c) Inserting Batteries into the Basis Station

• Open the battery compartment (19) on the back of the basis station.
• Insert 4 type AAA/Micro batteries into the basis station in the correct polarity (observe
plus/+ and minus/-). Close the battery compartment again.
• Right after inserting the batteries, the basis station will briefly display all display seg-
ments and a signal sound is audible. If only chaotic characters appear in the display,
take out the batteries for a few seconds and insert them again.
• Then the basis station shows the indoor temperature in the bottom display line. The
scan for the radio signal of the outdoor sensors will also be started; the reception
signal (7) will appear to the right of the channel number 1 and 2. The sensor search
can take several minutes.
Do not push any buttons, do not move the basis station and the outdoor sensors.
If the basis station does not display any measured data from the outdoor sensors after
several minutes, take the batteries from the basis station and outdoor sensors and
proceed again as described above.
35