Operating The Camera - Renkforce Rf-Hc-800 Bedienungsanleitung

To mount the camera, feed the fastening strap (included)
through the two feed-throughs (10) of the camera.
Hold the camera against a tree and fix the fastening strap.
Do not fully tighten it yet because you should align the cam-
era first.
Now you can align the wildlife camera.
Use the app to watch the live image (set the slide switch to "TEST") and select the optimum recording area.
Move within the desired trigger range and check the status LED of the PIR sensor (8). Each time it flashes means
that the camera has been triggered.
After positioning the wildlife camera as you wish, tighten the loose end of the fastening strap until the camera is
securely fastened.
To release the fastening strap, pull on the fastening strap tab.
Check all settings again and modify them if necessary.
When adjusting PIR sensitivity, consider the object or wild animal being monitored, as well as its size, speed and
distance of movement, to avoid false triggering.
Check that the time and date are set correctly.

12.2 Operating the camera

To switch the wildlife camera to Live mode, proceed as follows:
Move the camera's on/off slide switch (24) to the "ON" position for live operation.
The camera switches on and the display shows a timer that counts down from 10 seconds. The timer is also
Æ
indicated by the flashing Wi-Fi status LED (4).
When the timer has elapsed and the LED goes out, the camera is in live mode and ready for use.
Æ
53