Trial Run; Operation; Setting The Rotating Direction; Torque Control - Parkside Performance Pabsp 20 Li C4 Bedienungsanleitung Und Originalbetriebsanleitung

This product is equipped with an
automatic spindle lock to open or close
the chuck with the chuck ring
[ 1 ]
1. Open the chuck
ring in a counter-clockwise
[ 2 ]
direction (Fig. E).
2. Insert a suitable accessory tool into the
chuck as deep as required.
[ 1 ]
3. Close the chuck
accessory tool in position. Turn the
chuck ring in a clockwise direction.
[ 2 ]
˜ Trial run
NOTE
Always carry out a no-load trial
u
run before starting work and after
every accessory tool replacement.
Switch the product off immediately
if the accessory tool is not running
smoothly, if considerable vibration
occurs or if you hear abnormal
noises.
Before operating the product,
o
check whether the accessory tool is
correctly positioned, i.e. centred in the
chuck .
[ 1 ]
Screw bits are labelled according to
their dimensions and their shape.
If you are uncertain, always check
whether the bit fits tightly in the screw
head without any free play.
˜ Operation
˜ Gear selection
ATTENTION! Risk of product
m
damage!
Do not operate the gear
selector
4 ] [
come to a standstill.
Change the gear by sliding the gear
o
selector forwards or backwards
4 ] [
(fig. F).
18 GB
.
[ 2 ]
: Turn the chuck
1 ] [
: Hold the
1 ] [
until the product has
1 gear:
st
Suitable for:
Speed:
Torque:
2 gear:
nd
Suitable for:
Speed:
Torque:
˜ Setting the rotating direction
ATTENTION! Risk of product
m
damage!
Do not operate the rotation
direction switch
product has come to a standstill.
Change the direction of rotation
o
by pressing the rotation direction
switch towards the left or right
5 ] [
(fig. G).
When the rotation direction switch
is in the middle position, the on/off
switch is locked.
6 ] [
˜ Torque control
The torque can be adjusted by turning
the torque sleeve
Small screws or soft materials: Select
o
a low level.
Large screws, hard materials or
o
removing screws: Select a high level.
For drilling operation: Turn the torque
o
sleeve to the
[ 3 ]
˜ Switching on and off
NOTE
The on/off switch
u
locked.
Switching on: Press and hold the on/
o
off switch .
6 ] [
Regulate the speed as required (see
"Speed control") (fig. I).
Screwing
Low
High
Drilling
High
Low
until the
5 ] [
[ 5 ]
(fig. H).
3 ] [
position.
cannot be
6 ] [