Safety
Safety instructions
6
Note! Read carefully before use . Keep for future reference .
It is the responsibility of the operator to read and understand this manual and other informa-
tion provided and to apply the correct operating procedures .
Read the entire manual before starting up the unit for the first time . It is important to be
familiar with the correct operating procedures for the unit and all related safety precautions
to avoid the risk of personal injury and/or property damage .
The following safety instructions must be observed:
•
Ensure that all electric cables outside of the unit are protected from damage (e .g . caused
by animals) . Never use the unit if electric cables or the power connection are damaged!
•
Only install the unit in accordance with the national regulations for electrical connection .
•
Before carrying out maintenance, care or repair work on the unit, ensure the heat pump is
switched off and isolate from the mains power supply .
Observe the operating conditions specified in the section titled Technical data sheet .
•
•
Check accessories and connection parts for possible damage prior to every use of the
unit . Do not use any defective units or unit parts .
•
Do not use the unit in potentially explosive rooms or areas and do not install it there .
•
The unit shall be stored, installed and operated in a room with a floor area larger than
stated in the table contained in the section titled Refrigerant type and installed location .
•
Do not cover any air intakes or outlets at any point, except with accessories intended for
this purpose .
•
Never immerse the device in water .
•
Do not pierce or burn .
Any operation other than as described in this manual is prohibited . Non-observance renders
all claims for liability and guarantee null and void .
If any unauthorised modifications are made, any claims for liability and guarantee are ren-
dered null and void .
These units must only be operated by qualified (trained) personnel and repair of the refrigera-
tion circuit and the electrical system is to be performed by qualified personnel only . Failure to
do so may result in personal injury or damage to the equipment .
Stage of life
Activity
Installation
Operation
Maintenance
General maintenance
activities
Repair activities
Dantherm Group offers training on installation, operation and maintenance activities . Contact
in-formation can be found on the back page .
Target group
Qualified personnel
Operating personnel
Operating personnel
Qualified personnel
Safety: