Create Slush Maker Bedienungsanleitung Seite 13

2. Slide the auger mixer out of the evaporator. Put it aside.
3. Clean the evaporator with a damp cloth.
4. Gently slide the drain pan out of the unit, as there may be residual liquid in the pan. Put it
aside.
5. Clean the unit under the evaporator with a damp cloth.
6. If necessary, remove the drip tray and/or nozzle cover.
NOTE: The drip tray cover can be removed for easier cleaning.
7. Hand wash all parts in warm, soapy water, or use a dishwasher. If necessary, repeat the
process until all parts are completely clean.
NOTE: All parts, except the motor base and evaporator, are dishwasher safe (bottom rack
only) and should NOT be cleaned with a heat dry cycle.
8. Clean the motor base with a disinfected rag or a warm, damp cloth.
9. Allow all parts to dry completely before reassembling or storing the unit.
Store the machine upright and keep all parts assembled. When moving the machine, lift it
from the bottom of the engine base. Store the machine in a dry, ventilated place out of the
reach of children.
DO NOT store liquid inside the container.
This appliance features a unique safety system that prevents damage to the motor and
drive system in the event of accidental overload. If the unit is overloaded, the motor will
temporarily shut down. If this occurs, follow the reset procedure below:
1. Dallow the unit to cool for approximately 15 minutes
2. RRemove all parts and accessories. Make sure there are no ingredients clogging the
blender.
IMPORTANT: Make sure not to exceed the maximum capacity. This is the most common
cause of appliance overload. DO NOT process a solid block of ice or ice cubes. DO NOT make
smoothies or process hard or loose ingredients.
If your appliance still doesn't work, please contact Customer Service.
In compliance with Directives: 2012/19/EU and 2015/863/EU on the restriction of the use of dangerous
substances in electric and electronic equipment as well as their waste disposal. The symbol with the
crossed dustbin shown on the package indicates that the product at the end of its service life shall be
collected as separate waste. Therefore, any products that have reached the end of their useful life must
be given to waste disposal centres specialising in separate collection of waste electrical and electronic
equipment, or given back to the retailer at the time of purchasing new similar equipment, on a one for one
basis. The adequate separate collection for the subsequent start-up of the equipment sent to be recycled,
treated and disposed of in an environmentally compatible way contributes to preventing possible nega-
tive effects on the environment and health and optimises the recycling and reuse of components making
up the apparatus. Abusive disposal of the product by the user involves application of the administrative
sanctions according to the laws.
STORAGE
RESTART THE ENGINE
E NGLI SH
13