Security System; Troubleshooting; Transport And Storage - Create Baby Chefbot Bedienungsanleitung

• This appliance has a protection against switching on the appliance when there is no water
inside.
• As soon as the water container is emptied during the heating, sterilizing, and keeping warm
modes, the water shortage icon on the control panel will flash.
• In this case, add water to the tank and, as soon as the low water icon turns off, the appli-
ance can be started again.
• ATTENTION: Be careful when opening the water tank lid, steam can cause burns.
PROBLEM
Steam, sterilization or keep
warm mode does not start.
The blender, sterilizer, keep
warm or steamer mode
does not start.
• The device must be transported at temperatures between -10°C and 40°C with a maximum
relative humidity of no more than 75%.
• This device can operate at temperatures between 10°C and 40°C with a maximum relative
humidity not exceeding 65%.
• Store the appliance at a temperature of 0 to 30°C with a maximum relative humidity of no
more than 65%.
• Do not subject the appliance to sudden temperature changes.
• After transport or storage at low temperatures, it is necessary to keep the appliance at
room temperature for at least 2 hours before turning it on.
In compliance with Directives: 2012/19/EU and 2015/863/EU on the restriction of the use of dangerous substances in elec-
tric and electronic equipment as well as their waste disposal. The symbol with the crossed dustbin shown on the package
indicates that the product at the end of its service life shall be collected as separate waste. Therefore, any products that
have reached the end of their useful life must be given to waste disposal centres specialising in separate collection of
waste electrical and electronic equipment, or given back to the retailer at the time of purchasing new similar equipment,
on a one for one basis. The adequate separate collection for the subsequent start-up of the equipment sent to be recycled,
treated and disposed of in an environmentally compatible way contributes to preventing possible negative effects on the
environment and health and optimises the recycling and reuse of components making up the apparatus. Abusive disposal
of the product by the user involves application of the administrative sanctions according to the laws.

SECURITY SYSTEM

TROUBLESHOOTING

CAUSE
The water tank is empty.
The jug is not installed correctly
in the main body.
The jar lid is not installed
correctly.

TRANSPORT AND STORAGE

SOLUTION
Fill the water tank.
Install the jug into the main body
and turn it counterclockwise
until it stops.
The jug opening and the steam
outlet must be aligned.
Replace the lid on the jar and
turn it counterclockwise until it
clicks into place.
E NGLI SH
15