Herunterladen Diese Seite drucken

EUROM PAC 12.3 Compact Bedienungsanleitung Seite 42

Werbung

Automatically start
1. Set the device to the desired mode and the desired temperature.
2. Press the ON/OFF button, the device is now in standby mode.
3. Press the Timer button.
4. Use the Up and Down buttons to set the countdown timer. The device will automatically
start (1-24 hours).
5. Press the Timer button. The display shows the selected time until the device starts.
Automatically stop
1. Set the device to the desired mode and the desired temperature.
2. Press the Timer button.
3. Use the Up and Down button(s) to set the countdown timer. The device will automatically
stop (1-24 hours).
4. Press the Timer button. The display shows the timer indication and the selected
temperature.
Deactivate timer
To deactivate the timer function, press the "Timer" button until the timer indicator turns off.
Sleep mode
1. While in cooling mode, press the Sleep button to set the temperature. It increases 1 °C after
an hour and at most increases 2 °C after 2 hours.
2. Press the Sleep button again to cancel the setting.
Drainage of condensed water
The device extracts water from the air. The water is partially evaporated with the discharge of
the warm air. The remaining water accumulates in the water tank. When the tank is full the
device stops automatically and the message Ft will appear on the display.
1. Make sure the device is switched off and
the plug is removed from the power outlet
(Figure
33, pos. 1).
2. Remove the cap
from the water drainage point
(Figure
33, pos. 2).
3. Drain the tank in a container or a well.
4. Don't forget to put the cap back on the
water drainage point.
42
(Figure
33, pos. 3)
Figure 33.

Werbung

loading