EUROM PAC 12.3 Compact Bedienungsanleitung Seite 40

Installation to dehumidify
1. Make sure the device is switched off and
the plug is removed from the power outlet
(Figure 30, pos. 2).
2. Remove the rubber plug from the drain
(Figure 30, pos. 4).
3. Connect the included water drain hose
(Figure 30, pos. 1) to the drain of the
device.
4. Place the outlet of the water drain hose in
a bucket (Figure
5. Regularly check the water level in the
bucket. The end of the hose should not be
immersed in water.
In the dehumidifying mode it is not necessary
to mount the hot air outlet hose.
Remote control
1. Remove the cover
2. Remove the batteries (if present).
3. Insert two batteries (AAA 1.5V)
(Figure 31, pos. 2) in the battery
compartment as indicated. Make sure to
insert the batteries correctly.
4. Replace the cover.
40
30, pos. 3).
(Figure 31, pos. 1).
Figure 30.
Figure 31.