Werbung
Operation
WARNING
Before every use, make sure that:
• you operate the device with dry hands;
• the device is clean and dry;
• the device is not damaged;
• the device is not covered or blocked;
• the louvers are open;
• the device stands securely and horizontally.
1. Make sure the device is correctly installed.
2. Adjust the louvers by moving the handle
left/right
(Figure
wind direction.
3. Press the ON/OFF button on the device or
the remote control. The device will start in
Fan mode.
4. Press the Mode button on the device or on
the remote control to select the desired
mode.
Fan mode
1. Press the Speed button on the device or on the remote control to select the desired fan
speed (Low-High).
Cooling mode
1. Press the Up or Down button to set the required temperature (16 °C-32 °C).
2. Press the Speed button on the device or on the remote control to select the desired fan
speed (Low-High).
3. The device will stop cooling when the ambient temperature is lower than the required
temperature.
Dehumidify mode
1. Follow the instructions for
2. Regularly check the water level in the bucket, the end of the hose should not beimmersed in
water.
Timer
The device can automatically start and stop at a preset time.
32, pos. 1) to change the
Installation to dehumidify
Figure 32.
before choosing this mode.
41
Werbung
