Changing Access Point Settings; Configuring The Remote Access; Changing The Password; Parameterising The Controller Via Internet Browser - Resol Mx Plus Handbuch

If a WLAN is not displayed but to be used, proceed as follows:
1. Enter the WLAN name into the Network name (SSID) field.
2. Select the WLAN encryption type.
3. Enter the WLAN password.
4. Click the Join button.

3.25 Changing access point settings

If WLAN is activated, the access point will be automatically active.
In order to make access point adjustments, proceed as follows:
Î In the Configuration main menu, select the Network submenu.
In the Network name (SSID) menu item, the network name can be changed.
In the Password menu item, the access point password can be changed.
3.26 Configuring the remote access
ATTENTION! Third-party access!
When the default remote access password is not changed, third
parties may gain unauthorised access to the controller connected.
Î Change and note down the remote access password
and keep it in a suitable place.
The remote access password is required whenever a controller connected to the
device is to be accessed via the RPT Parameterisation Tool.
In order to change the remote access password, proceed as follows:
1. In the Configuration main menu, select the Remote access submenu.
2. Enter the new password into the Bus password field.
The factory setting for the remote access password is vbus.
3. Click Save configuration.
Bus access over local network and Remote access over Internet are
activated by default.
Î In order to deactivate the Bus access over local network and/or the Re-
mote access over Internet, click the corresponding toggle button.

3.27 Changing the password

In order to change the user password of the Web interface, proceed as follows:
1. In the Configuration main menu, select the Users submenu.
2. Under Change password click the toggle button.
3. Enter the current password into the Password field.
The password can be found on the last page of this manual and is also displayed
on then controller.
4. Enter the new password into the New password field.
5. Enter the new password into the Confirm new password field.
6. Click Save configuration.

3.28 Parameterising the controller via Internet browser

The controller can be parameterised via an Internet browser.
In order to parameterise the controller over an Internet browser, proceed as
follows:
1. Click the Parameterization main menu.
2. Click Open.
A new browser window opens in which all controller adjustments can be carried
out. Adjustments are made in the same way as on the controller.
29