Resol MX Plus Handbuch Seite 22

1.4.2 Using RPT via VBus.net
In order to use RPT via the Web portal, Remote access over Internet has to
be enabled, siehe Kap. 3.26 auf Seite 13.
With a Web portal account you can easily use RPT in order to parameterise the
controller over the Internet:
1. In the Web portal menu My Devices, click on Edit.
2. On the General settings page, tick the option Allow parameterization
using the via address and the RESOL Parameterization Tool (RPT).
3. Download and install the software.
4. Select the Communication menu.
5. Click Connect.
6. Select the DL2/KM1/KM2 interface.
7. Select the channel.
8. Enter the via tag from the Web portal menu item General settings into the
RPT field URL/IP.
9. Enter the password into the Password field.
10. Click Connect.
Note
After a reset, the device has to be added to the Web portal again.
22
2 Finding the device in the network
2.1 DeviceDiscoveryTool
The DeviceDiscoveryTool is a software that displays RESOL products connected
via the local network.
There are different possibilities to start the DeviceDiscoveryTool:
• Starting the tool from the hard disk after having downloaded it from https://
www.resol.de/de/software
• Starting the tool from the Web portal (under Tools)
Starting the DeviceDiscoveryTool
In order to start the DeviceDiscoveryTool, proceed as follows:
1. Open the folder discovery-tool-xxx.
2. Start discovery-tool Setup xxx.
3. Confirm all following dialogues with OK.
4. Click Start/Programs/discovery-tool.
5. Click Find devices.
All LAN-enabled RESOL products available in the network will be displayed.
6. Click the Open Web interface button of the corresponding device.
A new window with the Web interface will open.
7. Enter the password, siehe Kap. 3.1 auf Seite 23.
Note
The password can be found on the last page of this manual and is also
displayed on then controller as a data matrix.
2.2 IP address
The Web interface can be accessed by entering http://{IP address of the device}.
If the controller has been assigned an IP address via DHCP, it is displayed under
Status / Network / IP.