KLASS Fan MODULO REGULAR V2 Anleitung Seite 40

3 Blades Length
One of the blades may be 3 or 4 millimeters longer, because when it is installed,
by tightening the screws, the blade can slide upwards.
Check the distance from the center of your fan towards the blade tip.
If you notice that one of the blades is longer, loosen the screws ofthis blade, and
tighten them firmly, making sure the blade does not slip.
4 Blades Weight
Once you have measured the previous three points, switch on
your fan and check if it is vibrating.
If this is not the case, you have just finished installing your fan.
If you notice a vibration, proceed as follows:
Use the balancing kit, take the pliers from the kit.
On the first blade, at the end pinch the pliers and spin your fan.
If you notice that the fan does not vibrate, remove the pliers, use a 1 gram lead
and stick it at the end of the blade, on its upper side (facing the ceiling).
If the vibration continues, proceed for each blade in the same way until any
vibration disappears.
You have just installed your fan, enjoy it!
38