KLASS Fan MODULO REGULAR V2 Anleitung Seite 35

Installation of 3 Blades:
Locate the marks to install 3 blades on the motor board.
Place the three blades without tightening them to the end at this point.
Once the three blades are installed, adjust them so that the space between the
blades is minimal.
Now, tighten the screws to the maximum.
2 BLADES (ONLY P1, P2, P4)
ATTENTION!
unassembled item can slightly unbalance the fan. Please do not forget a
single element, screws, washers.
Screws
Blades
Be careful when assembling the parts, only one
Installation
Mark "3"
3 BLADES
33