Inspection & Maintenance - Cyrusher Rumble Montageanleitung

09
/
INSPECTION &
MAINTENANCE
Hand brake cut-off power
When your bike is equipped with brake cut-off power set, the bike will
automatically cut off power when the brake is used.
Low voltage protection
When the battery output voltage reaches its limit, the electronic control
system will cut off the power to automatically protect the battery.When
the battery reaches its minimum voltage, you can switch to pedal riding.
The battery should be recharged before riding again.
Power off
When your E-Bike is not in use, please turn off the power.
Charge indicator
Red indicates charging, green indicates that the battery is full.
Note: The battery switch must be turned off using the switch on the
bottom when the battery is charging. The battery must be fully charged
before the first use. We recommend you charge the battery for a full 6
hours after your first 3 uses. lf the bike is not used for a long time, you
should fully charge and remove the battery. While not in use, keep the
battery turned off and recharge every 2 months.
Make sure to keep the battery and charger away from children during
charging.
Do not attempt to disassemble or modify the battery or charger.
Do not use the battery or charger for any use other than its intended
purpose.
ASSEMBLY GUIDE | CYRUSHER RUMBLE
22