Routine Operation - Cyrusher Rumble Montageanleitung

Part2

Routine operation

1.General operation
By pressing and holding the button[ ],the display will start
to work. In the power-on state, by pressing and holding the
button[ ],your e-bike will be powered off. In the power-off
state, the display will no longer use the battery power, and
its leakage current will be less than luA.
If your e-bike is not used for more than 5 minutes, the display
!
will be automatically powered off.
2.Display interface switching
When the display is turned on, it will show the curent
Speed km/h and Trip Odometer
( )
Short press[ ]to switched cyclically between Trip
Odometer km , Odometer
( )
and Average Speed km/h
(
Trip Odometer
Odometer
km by default.
( )
km , Maximum Speed km/h
( ) (
).
Maximum Average
Speed Speed
3.Walk boost mode
Long press and hold[ ],the electric bicycle enters the
walk boost mode. Your e-bike will run at the constant
speed at the promoted speed and the display shows
[ ],Release[ ]to stop the power output immediately
and restore to the state before walk boost.
The walk boost mode can only be used when pushing the electric
!
bicycle, please do not use it while riding.
4.Headlight on/off
Press the button[ ]to make the controller turn on the
lights and the display backlight becomes dim. Press the
button[ ]again to make the controller tur off the lights
and the backlight restore briohtness
,
)
Figure 3-Helping
to implement the
display screen
ASSEMBLY GUIDE | CYRUSHER RUMBLE
Figure 4-Backlight
display interface
10