Battery Level Indicator - Cyrusher Rumble Montageanleitung

5.Assist level selection
Press the button [ ] / [ ] to switch PAS level of electric
bicycle, thus changing the motor output power.

6.Battery level indicator

The battery level indicator consists of five segments.
When the battery is fully charged, the five segments
will be all on.In case of under voltage, the outline of the
battery indicator will flash, which means the battery has
to be charged immediately.
4-
Full battery
segment segment
level
indication indication
indication
7.Error code indicator
When a fault occurs in the electronic control system of
your e-bike. the display will automatically indicate the
errorcode.Detailed definitions of error codes are shown
in Schedule 1.
Figure 5-Assist level
switching interface
11
3- 2- 1- Under
segment segment
voltage
indication indication
flashing
Figure 7-Error code
indicator interface
Part3 Personalized parameter
settings
All parameters can only be set when your e-bike
!
stops.
The personalized parameter setting procedure is as follows:
When the display is ON and the speed shows 0,
1 Press and hold the buttons [ ] and [ ] at the
( )
same time for more than 2s to enter the personalized
parameter setting interface;
2 Press the button [ ] / [ ] to switch between the
( )
personalized parameter setting interface, and press the
button [ ] to enter the parameter modification interface;
3 Press the button [ ] / [ ] to select the parameter,
( )
long press[ ] for addition operation, long press[ ] for
subtraction operation;
4 Press the button[ ] to save the parameter settings
( )
and return to the personalized parameter setting
interface;
5 Long press the button[ ] to save the parameter
( )
settings and exit the personalized parameter setting
interface.The following options are available on the
personalized parameter setting interface.