Scheppach DTS225 Originalbetriebsanleitung Seite 29

• The symbol of the crossed-out dustbin means that
waste electrical and electronic equipment must not
be disposed of with household waste.
• Waste electrical and electronic equipment can be
handed in free of charge at the following places:
- Public disposal or collection points (e.g. municipal
works yards).
- Points of sale of electrical appliances (stationary
and online), provided that dealers are obliged to
take them back or offer to do so voluntarily.
- Up to three waste electrical devices per type of
device, with an edge length of no more than 25
centimetres, can be returned free of charge to
the manufacturer without prior purchase of a new
device from the manufacturer or taken to another
authorised collection point in your vicinity.
- Further supplementary take-back conditions of
the manufacturers and distributors can be ob-
tained from the respective customer service.
13. Trouble shooting
Supposed malfunctions, faults or damage are often due to causes that can be rectified by the user. Therefore,
check the electric tool using the table below before contacting a specialist. Faults can be rectified quickly this way
in most cases.
Fault
Power tool does Power supply interrupted
not start
Power cord or plug defective
Other electrical defect of the electric tool
Power tool does Extension cable too long and/or cross-
not operate with full section too small
power
Power supply (e.g. generator) voltage is
too low
Poor operation Accessory worn out
results
Grinding plate worn out
Considerable dust Brush edge worn out
formation
Dust extraction not connected/switched on
Possible cause
www.scheppach.com
• If the manufacturer delivers a new electrical device
to a private household, the manufacturer can ar-
range for the free collection of the old electrical de-
vice upon request from the end user. Please contact
the manufacturer's customer service for this.
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal of
waste electrical and electronic equipment.
Remedy
Check power supply by connecting another
power tool
Have an electrician check the tool
Have an electrician check the tool
Use extension cable with permissible length
and/or adequate cross-section
Connect power tool to an appropriate power
supply
Have accessory replaced
Have grinding plate replaced
Have brush edge replaced
Connect / switch on dust extraction
GB | 29