Evolution R255 TBL Originalbetriebsanleitung Seite 4

before starting the saw.
• Assembling the stand** (figs. 1)
• Assembling the outfeed support* (fig. 2)
• Assembling the blade and riving knife (fig. 3)
SETTING UP THE SAW
• Using the rack and pinion fence (fig. 4)
Note: The fence can be installed in three positions atop the screws
installed in the extending rails (fig. 4.1). Use
positioning, position B for 0-550mm ripping, and
100-650mm ripping.
Aligning the rack and pinion fence (fig. 5)
•
Adjusting the cutting height (fig. 6)
•
• Using the push stick for rip cutting (fig. 7)
OPERATION
Powering the tool on/off (fig. 8)
•
90 º cutting (fig. 9)
•
• Bevel cutting (fig. 10)
• Mitre cutting (fig. 11)
Using the extended table (fig.12)
•
Attaching the clamp (fig.13)
•
• Dust extraction (fig. 14)
• Transporting the saw (fig. 15)
• Adjusting the kerf plate height (fig. 16)
MAINTENANCE
• Checking riving knife and blade parallelism (fig. 17)
Checking the blade at 45 º (fig. 18)
•
*Models R255TBL+ and R255TBLX+ only.
**Models R255TBLX and R255TBLX+ only.
***Models R255TBL and R255TBLX only.
position A for left
position C for