Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Receiver
•
•
•
•
•
•
•
•
•
•
•
•
Drive
•
batte
•
ry
•
•
•
•
•
•
•
•
•
•
•
•
Connect the servo to the receiver.
•
Connect the speed controller to the receiver.
•
Switch the transmitter on, and check that all sticks and trims are at centre (neutral).
•
Connect one of the drive batteries to the speed controller; the servo and the speed controller will now
•
take up their neutral positions.
Set the rudder system to the 'straight ahead' position and tighten the clamping screws in the swivel
•
connectors.
You can now program the speed controller (if necessary); please refer to the instructions supplied with
•
your speed controller.
Cut out the decals and apply them to the boat in the arrangement shown in the kit box illustration.
Running the boat
Fix the two batteries in the sponsons using self-adhesive Velcro tape.
The correct position of the batteries must be established by test-running the boat.
The boat should balance at a point 165 mm forward of the rear edge of the sponsons.
Trimming the boat
Place the model on a flat table top.
Loosen the two slot-head screws on the right-hand side of the rudder outrigger, and set the strut to the
correct height and angle: the strut and the hull should rest flat on the table top (see side-view).
The optimum setting must be established by test-running the boat.
The model should remain horizontal when planing.
Edge of table top
Important: Remember to re-tighten the screws after making any adjustments.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Keine Haftung für Druckfehler. Technische Änderungen vorbehalten!
Link lead, Order No. 3031
Water-cooling tube
#0059939
Speed controller
Drive
batte
ry
Screws
04/2008
21
Werbung
