GRAUPNER Powercat Anleitung Seite 17

Fix the upper hull section to the bottom shell using a few strips of adhesive tape.
•
1. Start by gluing
this area with Stabilit Express
Apply the tape at the transom and the front of the centre section only (see drawing) to avoid distorting the
hull.
When the glue has set hard, remove the weight and turn the boat over.
•
Remove the strips of tape at the stern, and apply Stabilit express to the central area at the stern. Press
•
it against the transom, apply more adhesive tape, and leave the glued joint to set hard.
Important: place the planing steps of the boat on a flat surface and weight it down once more while the
•
glue is curing.
When the joints have set hard, turn the boat over again and lay it down on its deck.
•
Now complete the joint with the bottom hull section by applying thick cyano or UHU-Plast Spezial all
•
round the flange in the top shell.
Important: don't use tape to hold the side-joints of the boat together, as this could cause
•
distortion in the hull sides.
Allow the glue to set hard, then check for gaps all round the hull seam and fill them with more adhesive.
•
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Keine Haftung für Druckfehler. Technische Änderungen vorbehalten! #0059939
17
04/2008