Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Glue the two plywood motor mount
•
supports (parts 16) to the central
area of the hull, at a point 190 mm
from the transom; use Stabilit
Express for these joints.
Drill two 4 or 5 mm Ø holes in the hull
•
floor exactly on the central 'V',
located 105 mm and 135 mm from
the rear edge, then form a fore-and-
aft slot by cutting out the piece of
plastic between the holes using a
sharp balsa knife. Caution: the
blade will tend to slip! It is better
to make several light cuts than
one heavy one.
The rudder system can now be
•
screwed centrally to the transom.
Slide the flexi-shaft through the strut
•
and the hole in the hull floor.
Solder the suppressor capacitor (part
•
31) between the two motor terminals
to form a bridge, and solder the
motor power leads (parts 32) to them at the same
time.
Saw off the projecting areas of the motor mount (18),
•
as shown in the drawing.
Fix the motor to the motor mount using the retaining
•
screws provided.
Attach the shaft coupling to the motor shaft by
•
tightening the clamping screws.
Push the coupling and motor onto the end of the flexi-
•
shaft. Slide the prepared plywood mount between the
plywood supports (parts 16) and the plastic motor
mount (part 18). Sand back the plywood mount to
match the angle of the supports.
Important: the flexi-shaft must not be kinked: it should
•
run in a smooth curve from the strut to the shaft coupling at the
need to adjust the slot in the hull floor to achieve this.
When you are confident that everything fits properly, glue the motor mount to the supports using Stabilit
•
Express.
When the glue has set hard, withdraw the flexi-shaft, slide the protective aluminium tube over the Teflon
•
sleeve and fit the Teflon sleeve from the strut into the inside of the boat. Now open up the slot in the hull
floor until the aluminium tube fits through it without distorting the shaft.
Screw the flexi-shaft to the shaft coupling at the motor, and glue the protective aluminium tube to the
•
hull floor by applying Stabilit Express to the joint on the inside and outside of the hull. Check that the
flexi-shaft rotates freely
Drill out to 2 mm Ø to accept
the swivel pushrod connector
Drill out the
•
holes in the
rudder lever
using a
2 mm Ø bit, and fit
the swivel pushrod connectors in the prepared holes; the
connectors must swivel smoothly when installed.
Press the rubber grommets (supplied in the servo accessory pack) into the servo mounting lugs, and
•
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Keine Haftung für Druckfehler. Technische Änderungen vorbehalten!
16
30
Saw off
#0059939
18
17
31
19
motor. You may
24
22
20
21
04/2008
19
32
23
19
Werbung
