VEVOR RP8626 Bedienungsanleitung Seite 549

8. Using a 3/8" socket, tighten the packing seal assembly. Torque to 5 Nm
(3.7 ft./lbs.)
9. Grease both ends of the packing spring and place it over the packing
seal assembly in the gun head.
10. Place the end cap over the packing spring so that the pilot inside the
end cap seats inside the packing spring.
11. Push the end cap toward the gun head while threading it into the gun
head. Using a wrench, tighten the end cap securely.12. Perform the
"Adjusting the Packing Seal Assembly" procedure described below.
Adjusting the Packing Seal Assembly
Proper adjustment of the seal assembly is essential to ensure
positive shut-off when the trigger is released .
1. Insert an 1/8" hex wrench through the hole in the center of the end cap
until it seats inside the packing seal adjustment screw.
2. Turn the packing seal adjustment screw clockwise until the ball on the
packing seal assembly can be felt seating into position. Then, turn the
screw 1/4 turn more for proper tension.
Replacing/Removing the Filter
1. Pull the bottom of the trigger guard forward so that it comes loose from
the handle assembly(9)
2. Loosen and remove the handle assembly from the gun head(10).
3. Pull the old filter out of the gun head(11).
4. Slide the new filter, tapered end first, into the gun head(12).
5. Make sure all the parts are clean and the handle seal is in position
inside the gun head.
6. Thread the handle assembly into the gun head until secure.7. Snap the
trigger guard back onto the handle assembly.
- 13 -