VEVOR RP8626 Bedienungsanleitung Seite 23

SETUP
Items in parenthesis () refer to the Feature identification drawing in the previous
section.
Note: The spray gun comes assembled from the factory. If the gun has been
disassembled for cleaning follow the steps below to reassemble.
1. Insert the mesh filter into the Handle (T) and align the handle with the upper
body of the spray gun.
2. While holding the upper body of the spray gun,tighten the Handle (T) using a
wrench.
3. Place the handle guard over the hole on the bottom of the handle, then secure
in place using the hose Inlet Port (V) adapter and two wrenches.
4. The Gun Tip and Guard consists of the following components:
A. Nozzle Tip Guard
B. Nozzle Tip Guard Retaining Nut
C. Metal Seat with Rubber Gasket
- 22 -