VEVOR RP8626 Bedienungsanleitung Seite 548

sprayer, hose, or gun. Static electricity buildup may result in a fire or
explosion in the presence of flammable vapors. Hold the gun firmly against
a metal container while flushing.
Maintenance
Follow all safety precautions as described in the Safety
Precautions section of this manual before proceeding.
NOTE: Refer to the Parts List section in this manual for part identification.
Replacing/Servicing the Seal Assembly
If your spray gun leaks or spits at the tip when you release the trigger, the
needle or seat is worn, damaged, or dirty and must be replaced or cleaned.
Never attempt to perform maintenance on the spray gun
without first performing the "Pressure Relief Procedure.
1. Perform the "Pressure Relief Procedure" and disconnect the fluid hose
from the gun.
2. Remove the end cap and the packing spring from the rear of the gun
head.
3. Using a 3/8" socket, remove the packing seal assembly from the rear of
the gun head.
4. Soak the removed parts in the appropriate solvent and wipe clean.
5. Inspect the parts for wear or damage and use new parts during
reassembly of the gun.
when necessary.
NOTE: Lubricate all pickings and moving parts before reassembly with a
lithium-based grease.
6. Make sure the two re-tractor pins inside the gun head are still in the
correct position7. Insert the packing seal assembly into the rear of the gun
head and thread it by hand until it stops.
- 12 -