VEVOR RP8626 Bedienungsanleitung Seite 22

4.When using a waste or solvent pail, ensure the pail is metal and is properly
grounded. Clamp one end of a ground wire to the pail the other end to a proper
ground, such as a metal water pipe.
5.Point the spray gun into the grounded waste or solvent pail while holding any
metal part of the spray gun firmly to the side of the pail to maintain ground
continuity of the gun and pail, then operate the trigger several times until pressure
within the hose has been relieved
6. Engage the trigger lock after pressure has been relieved.
7.Leave the Prime/Spray switch in the Prime position until you are ready to spray
again.
8. If you suspect the spray tip or hose is clogged or that pressure has not been
fully relieved after following these steps, CAREFULLY AND SLOWLY loosen the
tip guard retaining nut or hose end coupling to relieve pressure gradually, then
loosen completely before attempting to clear the any obstruction.
- 21 -