TESTING
1. Turn on the power.
2. Remove the motor/tank cover assembly and hold level.
3. Test the motor switch by raising the motor switch float with a finger
(Figure 6). The motor should turn on just before the float contacts cover.
4. Test the safety switch by raising the safety switch float with a finger. The
safety switch should activate before the float contacts cover.
5. Replace the motor/tank cover assembly on the tank.
This pump is suitable for gas furnace condensate applications. Caution
must be taken to ensure the acidity of condensate does not increase below
the average pH of 3.4 (to prevent localized pocket of acid that acts like a
battery causing pitting) by routinely cleaning or flushing the tank with fresh
water.
LIMITED WARRANTY
Your product is guaranteed to be in perfect condition when it leaves our
factory. It is warranted against defective materials and workmanship for a
period of 12 months from the date of purchase by the user.
Any product that should fail for either of the above two reasons and is still
within the warranty period will be repaired or replaced at the option of the
Ref center. All defective products returned under warranty will be fully
inspected to determine the cause of failure before the warranty is
approved.
DISCLAIMER: THE FOREGOING WARRANTY IS AN EXCLUSIVE
WARRANTY IN LIEU OF ANY OTHER EXPRESS WARRANTIES. ANY
IMPLIED WARRANTIES (INCLUDING, BUT NOT LIMITED TO, ANY
IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE) TO THE EXTENT EITHER APPLIES TO A
PUMP SHALL BE LIMITED IN DURATION TO THE PERIODS OF THE
EXPRESS WARRANTIES GIVEN ABOVE.
- 8 -