VEVOR RTP15WS115V Benutzerhandbuch Seite 7

PIPING
1.Run flexible tubing or pipe from the evaporator drain into one of the three
pump inlets. Be sure inlet piping is sloped downward to allow gravity flow
(Figure 4). Extend the inlet piping into the tank from 1 to 3 inches to ensure
that it will not interfere with proper float operation. Be sure that the inlet
piping is cut at an angle where it enters the tank.
2.The outlet piping should be flexible tubing secured with a hose Clamp
(not provided) or pipe (3/8 inch ID. maximum to prevent excessive flow
back to the unit). From the condensate unit, extend the discharge piping
straight up as high as necessary. Do not extend this line above the
head/GPH of the particular model being installed. From this high point,
slope the discharge line down slightly to a point above the drain area, then
turn down and extend to a point below or approximately level with the
- 6 -