Safety Precautions - PeakTech 6095 Bedienungsanleitung

1. Safety Precautions

This product complies with the requirements of the following European Community Directives:
2004/108/EC (Electromagnetic Compatibility) and 2006/95/EC (Low Voltage) as amended by
2004/22/EC (CE-marking).
To ensure safe operation of the equipment and eliminate the danger of serious injury due to short-
circuits (arcing), the following safety precautions must be observed.
Damages resulting from failure to observe the safety precautions are exempt from any legal claims
whatever.

Prior to connection of the equipment to the main outlet, check that the available mains
voltage corresponds to the voltage setting of the equipment.

Connect the main plugs of the equipment only to a mains outlet with earth connection.

To avoid electrical shock, do not operate this product in wet or damp conditions.

Do not cover the ventilation slots of the cabinet to ensure that the air is able to circulate
freely inside.

Do not insert metal objects into the equipment by way of the ventilation slots.

Do not place water-filled containers on the equipment (danger of short-circuit in case of
know-over the container).

Do not operate the equipment near strong magnetic fields (motors, transformers etc.).

Do not operate the meter before the cabinet has been closed and screwed safely as
terminal can carry voltage.

Replace a defective fuse only with a fuse of the original rating. Never short-circuit fuse or
fuse holding.

Check the test leads and probes for faulty insulation or bare wires before connection to the
equipment.

Please use only 4mm-safety test leads to ensure immaculate function.

Conduct measuring works only in dry clothing and rubber shoes, i. e. on isolating mats.

Comply with warning labels and other info on the equipment.

The measurement instrument is not to be operated unattended.

Do not subject the equipment to direct sunlight or extreme temperatures, humidity or
dampness.

Do not subject the equipment to shocks or strong vibrations.

Keep hot soldering irons or guns away from the equipment.

Allow the equipment to stabilise at room temperature before taking up measurement
important for exact measurements).

Periodically wipe the cabinet with a damp cloth and mid detergent. Do not use abrasives or
solvents.

The meter is for indoor use only.

Do not store the meter in a place of explosive, inflammable substances.

Opening the equipment and service- and repair work must only be performed by qualified
service personnel.

Do not modify the equipment in any way.

The cable cross-section of the connecting cables used must output side at least 2.5 mm²,
the cable length should not exceed 3m.

Measuring instruments don't belong to children hands
-9-