Connection And Operation - PeakTech 6095 Bedienungsanleitung

5. Connection and Operation

5.1. Setting the mains supply voltage
Setting of the mains input voltage to supply the lab power supply can be adjusted internally. By
default, the mains input voltage is 180 - 240 V set.
1. Loosen the screws and removing the housing cover
2. Adjust the mains input voltage (see figure)
Select the appropriate voltage setting:
PIN L1 = mains input voltage 90 - 130V
PIN H1 = Mains input voltage 180 - 240V
3. Replace the housing cover and secure it with the screws
ATTENTION!
Laboratory power supply unit does not operate when it is not completely closed.
-12-