DEFA Power S Bedienungsanleitung Seite 28

13. If more than one Wall Bracket is to be installed, repeat the steps from 1 to 12.
NO Hvis mer enn én veggbrakett skal installeres, gjenta trinnene fra 1 til 12.
SE Upprepa steg 1 till 12 om fler än ett väggfäste ska installeras.
DK Hvis der skal installeres mere end ét vægbeslag, gentages trinnene fra 1 til 12.
FI Jos seinäkiinnikkeitä asennetaan useampi, toista kohdat 1–12.
DE Wenn mehr als eine Wandhalterung installiert werden soll, die Schritte 1 bis 12 wiederholen.
FR Si plusieurs supports muraux doivent être installés, répéter les étapes de 1 à 12.
ES Si se va a instalar más de un soporte de pared, repita los pasos del 1 al 12.
IT Se devono essere installati più di un supporto a parete, ripeti i passaggi da 1 a 12.
NL Als er meer dan één muurbeugel moet worden geïnstalleerd, herhaal dan de stappen van 1 tot 12.
Install the Ethernet cable
Continue to the next section if no Ethernet cable is to be
installed. For LAN connection, the Ethernet cable can be
inserted in the LAN port on the back of the Charging Unit
before the Charging Unit is installed.
Follow these steps:
1. Make a hole through the rubber grommet with an awl.
2. Insert the LAN cable through the hole of the grommet.
3. Thread the LAN able through the Wall bracket.
4. Remove the rubber grommet from the LAN port.
5. Make a hole through the rubber grommet with an awl.
6. Push the LAN cable through the hole of the grommet.
7. Attach the RJ45 connector to the LAN cable.
8. Connect the LAN cable into the LAN port.
9. Slide the grommet over the cable and firmly into the
LAN port enclosure. The grommet now protects the LAN
connection from water and dirt.
6
7
28
5
4
1
2
9
8
3
defa.com