Scheppach DP55 Original Bedienungsanleitung Seite 34

• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal of
waste electrical and electronic equipment.
15. Troubleshooting
Fault Possible cause
Motor, cable or plug defective, build-
ing circuit breaker tripped
Device does not start
On/off switch (11/10) defective
Motor defective
Base plate (1) not fastened in place.
Heavy vibrations
Drill bit not clamped centrally
Motor overheats Overloading of the motor, insufficient
easily cooling of the motor.
Motor makes exces-
Coils damaged, motor defective.
sive noise
34 | GB
Remedy
Check power outlet, mains connection cable,
mains plug. Have repair carried out by electrical
specialist. Check building circuit breakers.
Repair by customer service department
Repair by customer service department
Secure machine to a work bench or similar
Check drill bit in chuck (14)
Avoid overloading the motor while drilling, remove
dust from the motor in order to ensure optimal
cooling of the motor.
Have checked by customer service department
www.scheppach.com