Checking The Charging Level Of The Battery Pack On The Product; Working Instructions; Sawing Without Guide Rail - Parkside Performance Pptsa 20-Li C3 Bedienungsanleitung Und Originalbetriebsanleitung

˜ S i i
Switching on
1. Push the switch lock
2. P e he on o
Once the product starts running, you
can release the switch lock
3. Plun e he a
workpiece.
S i i
1. Relea e he on o
2. u de he a
guard cover .
[ ]
˜ Checking the charging level
of the battery pack on the
product
The charging level of the battery
o
pa k is indicated by illumination
[ ]
of the corresponding LEDs on the
ha n level nd a o
During operation, the charging level
o
o he a e pa k
displayed on the charging level
nd a o .
[ ]
Colour
Red, orange, green Fully charged
Red, orange
Red
ha e he a e
o
only the red LED on the charging level
nd a o is illuminated.
[ ]
˜ Working instructions
NOTE
The cutting width markings
u
the guard cover
and rear cutting point of the saw
lade
[ ]
cutting depth.
forward.
[ 3 ]
h .
[ 5 ]
.
[ 3 ]
lade into the
[ ]
h .
[ 5 ]
lade back into the
[ ]
.
[ ]
is permanently
[ ]
M i
Half charged
Needs to be
charged
pa k when
[ ]
on
[ ]
show the front
[ ]
0 at maximum
˜ Sawing without guide rail
Right-angled sawing
1. old he p odu
hand on the handle
hand on the auxiliary handle
2. Switch on the product (see "Switching
on o "
3. Place the product with the front part of
the saw table
[
4. Plun e he a
workpiece. Saw forward with moderate
pressure – never backward.
Mi
1. Set the desired cutting angle (see
"Adjusting the cutting and mitre
an le"
2. old he p odu
hand on the handle
hand on the auxiliary handle
3. Switch on the product (see "Switching
on o "
4. Place the product with the front part of
the saw table
[
5. Plun e he a
workpiece. Saw forward with moderate
pressure – never backward.
Plunge cuts
NOTE
Reduce the risk of kickback by
u
placing the rear edge against a stop
e he u de a l
Moving sideways during the cut
u
an au e he a
resulting in kickback. When making
plunge cuts that are not made at a
h an le e u e he a
against moving sideways.
1. Set the desired cutting depth (see
"Ad u n he u n dep h"
2. Place the product on the workpiece.
h o h hand one
and the other
6 ] [
.
[ 1 ]
on the workpiece.
]
lade into the
[ ]
h o h hand one
and the other
[ 6 ]
.
[ 1 ]
on the workpiece.
]
lade into the
[ ]
[ ]
lade to jam,
[ ]
a le
[
GB
]
21