Additional Instructions; Vibration And Noise Reduction - Parkside Performance Pptsa 20-Li C3 Bedienungsanleitung Und Originalbetriebsanleitung

d Always observe that the guard is
covering the blade before placing
unprotected, coasting blade will cause
the saw to walk backwards, cutting
whatever is in its path. Be aware of the
time it takes for the blade to stop after
the switch is released.
˜ Additional instructions
D
Select the correct saw blade based
i
blades that are intended for cutting
wood or similar materials must
o pl h EN
product for cutting wood, plastic and
lightweight building materials (e.g.
pla e oa d
Only use saw blades with a speed
i i
Only use saw blades with a diameter
0
i
M
When sawing plastic, make sure the
i
P i
cutting depth (see "Technical data")
W i
A
Do not use any accessories
that are not recommended by
PARKSIDE (see "Replacement parts/
Accessories") This can result in
ele ho k o
Safe working
Do not exceed the maximum speed
stated on the product. If indicated, the
speed range must be complied with.
Take circular saw blades with cracks
in them out of service. A repair is not
permitted.
Do not use tools with visible cracks.
16 GB
An
i
Saw
7-1. Only use the
i
i
i
i
i
i i
e
Clean tools regularly.
Only clean tool parts made of light
metal alloys with solvents that do not
impair the mechanical properties of
these materials.
Tighten tools and tool bodies in such
a way that they cannot become loose
during operation. Heed the information
on assembly. Tighten the clamping
screw holding the saw blade in place
hand-tight using the enclosed hex key.
Extending a spanner or tightening
with the help of hammer blows is not
permitted.
Clean the tightening surfaces on the
saw blade to remove any dirt, grease,
oil and water.
Use original spare parts from the
manufacturer to ensure safe use (see
"Repla e en pa
Ma n enan e o k and
to circular saw blades should only
be performed by a professional,
i.e. a person with specialist training
and experience who is familiar with
the design requirements and the
necessary safety steps.
˜ Vibration and noise reduction
To reduce the impact of noise and
vibration emission, limit the time of
operation, use low-vibration and low-noise
operating modes as well as wear personal
protective equipment.
Take the following points into account to
minimise the vibration and noise exposure
k
Only use the product as intended by
its design and these instructions.
Ensure that the product is in good
condition and well maintained.
Use correct accessory tools for the
product and ensure they are in good
condition.
Keep tight grip on the handles/grip
surface.
A e o e "
od a on