Safety Instructions For All Saws; Further Safety Instructions For All Saws - Parkside Performance Pptsa 20-Li C3 Bedienungsanleitung Und Originalbetriebsanleitung

D
E po u e o
e pe a u e a ove
explosion.
Follow all charging instructions
and do not charge the battery
pack or tool outside the
i i Charging improperly or
a e pe a u e ou de he pe
range may damage the battery and
n ea e he k o he
Service
a Have your power tool serviced by
i
i i
will ensure that the safety of the power
tool is maintained.
Never service damaged battery
Service of battery packs
should be only be performed by the
manufactured or authorized service
providers.
˜ Safety instructions for all
saws
Cutting procedures
a DANGER: Keep hands away
from cutting area and the
If both hands are
holding the saw, they cannot be cut by
the blade.
Do not reach underneath the
i The guard cannot
protect you from the blade below the
workpiece.
Adjust the cutting depth to the
i
than a full tooth of the blade teeth
should be visible below the workpiece.
14 GB
i
e o
0 a au e
i i
ed
e
i i
This
i Less
d Never hold the workpiece in your
hands or across your leg while
i S
support the work properly to minimise
body exposure, blade binding, or loss
of control.
e Hold the power tool by insulated
gripping surfaces, when performing
an operation where the cutting tool
i
with a „live" wire will also make
exposed metal parts of the power tool
„live" and could give the operator an
electric shock.
When ripping, always use a rip fence
i
the accuracy of cut and reduces the
chance of blade binding.
Always use blades with correct size
and shape (diamond versus round)
match the mounting hardware of the
a ll un o
control.
h Never use damaged or incorrect
washers and bolt were specially
designed for your saw, for optimum
performance and safety of operation.
˜ Further safety instructions for
all saws
Kickback causes and related warnings
Kickback is a sudden reaction to a
pinched, jammed or misaligned saw
blade, causing an uncontrolled saw to
lift up and out of the workpiece toward
the operator.
When the blade is pinched or jammed
tightly by the kerf closing down, the
blade stalls and the motor reaction
drives the unit rapidly back toward the
operator.
i
It is important to
i i Contact
i This improves
Blades that do not
en e au n lo
The blade
o