Eview2 Instructions; Device Status Window; Echo Diagram (Oscilloscope Function) - +Gf+ 2298 Bedienungsanleitung

Type 2298 80 GHz Radar Level Sensor
6

EView2 Instructions

If necessary, install the EView2 HART configuration software.
Electrical connections: Start the program and search for the transmitter with the program (for more information, see also EView2
user manual).
From the devices found during the detection, select the device you want to configure or program and open the "device program-
ming" window of the device. All the necessary parameters and function settings can be changed with EView2. This chapter only
describes the specific functions related to Type 2298's and two programming examples.
6.1

Device Status Window

To invoke the "Device Status Window" in EView2, right-click on the device line in the "Device List" in the main window and select
the "Show Device Status Window" menu item in the popup window. This window shows the status and error messages of the Type
2298. The "Device Status Window" can also be summoned in the "Polling" window by activating the corresponding check box.
6.2

Echo Diagram (oscilloscope function)

Click the "Echo Diagram" button in EView2 to display the device's Echo Diagram. A window called "Echo map" will appear. This dia-
gram shows the reflection curve measured by the device. In addition, this window can be used to adjust the threshold level. To update
the chart or read the data, press the "Refresh" button on the bottom line of the window (or press the F4 key).
After a successful reading, an echo graph similar to the attached "Echo Diagram" appears. The displayed information content can be
selected in the legend. The "Echo list" displays the location and data of the echo peaks evaluated by the device, of which the selected
level signal is marked with the inscription "Selected peak."
46
Instruction manual